Remove and reinstall four wheels and rear drums( if applicable) to inspect brake condition. Inspect entire system for leaks. Lining remaining is: Front ( %) Rear ( %)
BRAKE SHOES &/OR PADS – Remove & Replace – 2.0L Eng Rear,Both Sides – [Includes: Clean, lube and/or replace Brake Hardware as necessary. Adjust Brakes (where applicable). Includes: Repack Wheel Bearings (where applicable). DOES NOT include refinishing.]
Replace front pads & rotors, lubricate all parts necessary, and road test vehicle.
WHEEL CYLINDER – Remove & Replace – 2.0L Eng Rear,Both – [Includes: Repack Wheel Bearings (where applicable), bleed System and replace Shoes (if necessary).]
Lube, oil, and filter
Ruth H. gave our service a 5 star review on 5/26/2023
Lubricate and check chassis. Change oil and oil filter. Check air filter and breather filter. Check all fluid levels under hood and tire pressures. Preform basic safety inspection.
CAMSHAFT POSITION SENSOR – Remove & Replace – w/Induction Manifold,Removal,One,Right Bank – [Includes: R&I Induction Manifold.]
TIE ROD &/OR END – Remove & Replace – Inner,One Side – [Includes: R&I Outer Tie Rod Ends.] – [Includes: Adjust toe-in only. NOTE: Deduct .4 if alignment is also performed. NOTE: Manufacturer recommends removal of Rack and Pinion Steering Gear when replaci
Road test vehicle. Check all suspension and steering parts for wear. Check caster and camber angles and adjust as required. Check and set toe-in as required. Center steering wheel.
DIFFERENTIAL COVER GASKET – Remove & Replace
Cam H. gave our service a 5 star review on 4/17/2023
Lubricate and check chassis. Change oil and oil filter. Check air filter and breather filter. Check all fluid levels under hood and tire pressures. Preform basic safety inspection.
Carol S. gave our service a 5 star review on 1/26/2023
Check charging system for proper output to battery. Load test battery. Check all wiring. Inspect belt and adjust as required. Test for current draw on electrical system and record findings.